RAM on the computer is not exceeded during the calculation. This helps with making sure that the available amount of physical The Approximate Maximum Cells option allows for limiting the total number of cells created during the refinement process. For example, if the refinement level is set to three, and there are two-level initial mesh cells, the solution adaptive refinement process can split these cells down to five-level cells. The Refinement level specifies how many times the initial mesh cells can be split to achieve the solution-adaptive refinement criteria. If the project was created without initially enabling the solution adaptive mesh refinement option in the wizard, it has to be turned on manually through the Calculation Control Options dialog window.Ĭalculation Control Options – Refinement tab Setting the Result resolution slider bar to a level six or higher on the Results and Geometry Resolution screen of the Wizard automatically enables the solution adaptive mesh refinement option. Question: How do I enable the solution adaptive mesh refinement option?Īnswer: This can be done in two different ways, during the initial setup of the Flow Simulation project and after the project has already been created. The mesh starts from an initial state and is modified during the calculation based on user-defined settings. This ensures better accuracy during the calculation. The software splits the mesh cells into the high-gradient flow regions and merges the cells in the low-gradient flow regions. SOLIDWORKS Flow Simulation can adapt the computational mesh to the solution during the calculation.
0 kommentar(er)
